My Cart  

product (empty)

Brands

Home>Pump Accessories>Pump Controllers and Pressure Switches>Davey Torrium

Davey Torrium

Davey Torrium

Torrium® is an advanced micro-processor equipped pump controller that measures flow, pressure, voltage and time to provide outstanding pump control for home pressure systems.
Ideal for pumps with clean, non-volatile liquids without fibres or solids in such applications as :-

  • Household water supply
  • Irrigation
  • Water transfer
  • Washing systems
  • Pressure boosting

On sale On sale!
$349.60 GST incl.

Availability: Item currently in stock.

Available in two models:

T45 has shut off head range of 150kpa-450kpa

T70 has shut off head range of 450kpa-700kpa

 

MADE IN AUSTRALIA

  • Torrium® starts pump on pressure drop and stops pump on low  flow (~2 lpm), thus reducing pump cycling for constant and even water pressure.
  • Torrium® measures the pump shut off head each time the pump stops, and sets the cut-in pressure at 80% of shut-off head, so that the consumer is unlikely to notice any pressure change when the pump is switched on.
  • Torrium® adapts each time the pump stops, thus allowing the system to accommodate variations in pump performance or site conditions.
  • Torrium® has a simple indicator and fault LED system.  Red constant means that the system is in standby.  Green constant means the pump is running.
  • Cistern Fill mode is activated when the Torrium® detects frequent short cycling, such as may be encountered with a very slow filling toilet cistern.  The Torrium® will then ensure the pump continues to operate for at least 2 minutes.
  • Torrium® stops the pump in loss of prime circumstances and activates the loss of prime LED indicator sequence (red LED single flash per sequence), thus:-
  • Protecting the pump from dry run damage Helps identify installation faults
  • When the Torrium® detects loss of prime it waits 5 minutes then goes into auto retry mode, whereby it will restart the pump to see if prime can be re-established automatically.  Auto retry occurs at 5 minutes, 30 minutes, 1 hour, 2, 4, 8, 16 and 32 hours.  Torrium® will also retry if it detects flow through the system (eg from mains water pressure returning).
  • If Torrium® detects excessive electrical current, such as when a the pump motor is subjected to lock rotor or when someone tries to manually override the Torrium® by holding in the prime button, the Torrium® will shut the pump down and indicate 2 red flashes per sequence.
  • Should the Torrium® detect low incoming voltage (below 180 volts) it will allow the pump to continue to operate if possible, but it will flash two red flashes per sequence over the green run LED.
  • Incoming power lead fitted is2m long with Australian three pin plug.
  • Power lead to pump motor is 0.67m long with connection for standard Davey motor up to 1.0kW

 

Please do not hesitate to call us on 0800 244 377 if you have any questions or the product you are after is not here.